Thinking about the steel slats.

[USFREEDOM911]

Can you describe what saw leaves irregular marks and not a smooth straight cut line?

It's that new cutting torch saw.

[tinfoil]

There were dozens of links repeating the "sawed" description from news outlets. Not one reporter or news editor out there is smart enough to recognize the marks of a plasma cutter. That's fucking sad!

[PostmodernProphet]

I'd be willing to bet it would still be possible, just not as easy as if it were empty square steel tube.

what are you going to say to the border patrol office when he comes up and asks you what the fuck you think you're doing?.......

[PostmodernProphet]

Rents for less than 200 Pesos a day in Mexico! LOL!

would never be noticed by the border patrol.......

[reagansghost]

would never be noticed by the border patrol.......

neither would a Home Depot hacksaw and 10 minutes of work

[tsuke]

cement is smashable too

i mean if illegals are smashing and cutting through our infrastructure then yeh we should be concerned about them.

[Darth Omar]

Do you seriously think those were sawed through? There were obvious signs of a plasma cutter.

The concrete filler would prevent the jack from doing much since you wouldn't be able to get the surface to pinch and bend because the concrete would transfer the energy internally instead of the metal.

Your engineering prowess gives me chill bumps.

[PostmodernProphet]

neither would a Home Depot hacksaw and 10 minutes of work

lol.....so you think you can squeeze your senorita through the wall in ten minutes?.........she must be mighty skinny.......

[Darth Omar]

would never be noticed by the border patrol.......

Never mind the fact you’d have to jump off the end of it lol.

[tinfoil]

neither would a Home Depot hacksaw and 10 minutes of work

LOL a hacksaw? Do you even know what a hacksaw is? Hint: It's not a power tool.

With a hacksaw you wouldn't even make a mark on hardened steel. 10 minutes? The blade wouldn't even last that long.

You might be able to cut through with a die grinder and about a dozen disks and an hour for each post.

Plasma cutter would cut through in about half an hour and make little noise. Hauling the shit to do that would require a vehicle

[PostmodernProphet]

Never mind the fact you’d have to jump off the end of it lol.

I was going to say that but I assumed he would just say they could rappel down.....

[tinfoil]

Your engineering prowess gives me chill bumps.

LOL
Physics: How does it work?

[Darth Omar]

LOL a hacksaw? Do you even know what a hacksaw is? Hint: It's not a power tool.

With a hacksaw you wouldn't even make a mark on hardened steel. 10 minutes? The blade wouldn't even last that long.

You might be able to cut through with a die grinder and about a dozen disks and an hour for each post.

Plasma cutter would cut through in about half an hour and make little noise. Hauling the shit to do that would require a vehicle

What it amounts to is this: yes, a steel barrier can be defeated.

Efficiently? No.

Results: illegal immigration is cut down to bare minimum.

Cost effective? No brainer.

[USFREEDOM911]

would never be noticed by the border patrol.......

They must be trying to figure out how to have one on the other side, so they don't have to fall.

[Darth Omar]

They must be trying to figure out how to have one on the other side, so they don't have to fall.

Well, under current laws they’d have to be medically treated once they ‘drop in’, so I wouldn’t put it past them.